Lose contact with PBX when node is active

Configuring synchronization, sensors, and optimizations
Post Reply
User avatar
Posts: 175
Joined: Sun Nov 27, 2016 3:41 pm

Lose contact with PBX when node is active

Post by crmuser » Mon Mar 26, 2018 3:54 pm

I am setting up a small office PBX cluster. My network settings are:

Active Node: IP, Netmask
Passive Node: IP, Netmask
VoIP NIC: IP, Netmask

When either node goes active I lose contact with it - sometimes, from some phones. What is going on?
Account for questions transferred from CRM system
User avatar
Telium Support
Posts: 235
Joined: Sun Nov 27, 2016 3:27 pm

Re: Lose contact with PBX when node is active

Post by Telium Support » Mon Mar 26, 2018 3:58 pm

I think you are missing some basics concepts of networking. Your description above shows two NIC's on the same subnet. That will confuse Linux as it is not sure which NIC to use for incoming/outgoing traffic.

Carefully review section 2.4 of the HAAst installation guide before going any further. If you are new to networking/multihoming/routing then you will find all HA product difficult to install or get working properly.

If this is for a commercial environment I would recommend you engage Telium professional services to perform the installation for you (or at least the network/VoIP NIC portion). If you wish, our engineers can also walk you through the key concepts of networking and multihoming, to help you understand what they configured and why.
Post Reply